Amana Tool DRB-216 Polycrystalline Diamond (PCD) Tipped Compression Up/Down Shear R/H Direction 5/8 Dia x 1-5/8 Cut Height x 5/8 Shank Router Bit

For CNC Use Only.

Diamond is the hardest material on the earth. Polycrystalline Diamond (PCD) tooling is manufactured in a high-temperature and high-pressure laboratory that fuses diamond particles onto a carbide substrate, which allows the diamond to be brazed onto a tool body.

PCD Tooling Benefits:

Harder cutting edge provides higher resistance to wear
Cut thousands of feet more than carbide without changing tool, saving setup time
Optimized machine tool efficiency
Quality of finish is often significantly improved
If you’re looking for the ultimate in tooling, you’ve found it! Amana Tool®'s PCD tipped compression CNC router bits will groove, joint and rabbet a wide variety of tough, abrasive materials including composites, particleboard, MDF (both raw or with melamine), veneer and hardwoods.
 
The cutting edge lasts much longer than carbide for extremely long life. Depending on the material being cut, PCD tooling has been known to out perform a carbide tool by a ratio of 300:1. However, to be conservative in your buying decision, we suggest you base your expectations on 25:1 ratio over carbide tooling.

Excellent for cutting:

Aluminum
Aluminum Composite Material (ACM)
Composite panels
Custom composite materials
Fiberglass
Fiberglass PCB board
Fiber-reinforced urethane
Fiber-reinforced structural foam floors
Lightweight composites
MDF
Plywood
Plastic
Hard and soft wood
Multipliers for different materials:
Chipboard without coating: Max RPM x 1.1%
Cross grain veneer: Max RPM x 0.7%
MDF: Max RPM x 0.8%.